Prior to the restoration, the plan view of the deckhad a number of humps and hollows down the length of the yacht\u2019s topsides. This unfairness could not be rectified during re-framing because the hull planking was used as the former for the new frames and the deformations were not large enough to justify removal of large areas of hull planking at the same time.<\/span><\/span><\/p>\n The unfairness in the topsides was therefore rectified by epoxy gluing sipo strips to the outside faces of the hull planking at and below the deck edge (max thickness 8mm in the least fair area aft but on average 3mm).<\/span><\/span><\/p>\n In order for the plan view of the ply batten to be a fair line, the wooden stanchions have then in turn had oak added to their outboard faces at the areas where sipo has been added to the topsides. This is so that the bulwark rail will be fair when viewed from above, something that has not been the case fora number of years with Armide.<\/span><\/span><\/p>\n Likewise, when Armide arrived at Classic Works she was hogged at both sets of chain-plates. This hogging, caused by the tension in the yachts rigging pulling the sides of the yacht upwards over many years, had left permanent bumps of up to about 4 cms in both sides of the sheer-line at the level of the masts\u2019 chain-plates.<\/span><\/span><\/p>\n This hogging was taken out during the re-framing and re-decking of the yacht and the deep ply batten is now being used for final checks on the heights of all the oak stanchions to ensure that the sheer-line is fair and correct. Once that is done, the teak bulwark rail can be fitted and then the capping rail.<\/span><\/span><\/p>\n Photos of recent works undertaken<\/p>\n